Installing A Power Supply; Connecting The Power Cord - H3C WX3820X Installation Manual

Installing a power supply

CAUTION:
Do not install an AC power supply and a DC power supply on the same device.
1. Remove the filler panel (if any) from the slot where you want to install a power supply with a
Phillips screwdriver.
Keep the remove filler panel for future use.
2. Holding the handle of the power supply with one hand and supporting the bottom of the power
supply with another hand, push the power supply into the slot along the guide rails until the
power supply is completely inserted.
3. Use a Phillips screwdriver to fasten the captive screws on the power supply.
Figure2-20 Installing an AC power supply
Figure2-21 Installing a DC power supply

Connecting the power cord

WARNING!
2-17