6
Connecting the power cord
CAUTION:
To avoid bodily injury, connect the power cord first to the device and then to the power supply
system in the equipment room.
To connect the power cord:
1.
Release the jaw of the cable clamp.
2.
Slide the cable clamp outward along the cable mount.
3.
Open the cable clamp, thread the power cord through the cable clamp, and close the jaw.
4.
Connect the female connector of the power cord to the power receptacle on the power supply.
5.
Slide the cable clamp forward to secure the power cord in place.
6.
Connect the other end of the power cord to the power supply system.
Figure6-1 Connecting the power cord
Copyright © 2021, New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.
5