1.5 Security instructions
The security rules regarding transfer system, especially those related to electrical
equipment must be followed during all using states: installation, transportation,
production. To not follow these rules would be considered as bad use of the device.
Use the transfer in an explosive area may affect the integrity of the conveyor and is
strongly not recommended.
Never handle maintenance operation alone: another person must be compulsory present
in order to turn off power and apply first aid if necessary.
The modification of motor position, or removal of safety spare parts should be done only
when the conveyor is unplugged from any power source.
During any handling on the moving transfer or nearby (use, tension setting of the belt ...),
do not slide your hand between the belt is the support to prevent from any accident.
During the manipulation or using of the working transfer line, be careful of pinching
areas indicated by this pictogram.
1.6 Motor's safety instructions
In the case of a power failure, the motor relay must fall, restarting the engines will be
gradual and cycled with the restart of the plant. The engines are not suddenly restart
when power is restored to the installation.
In contrary to the three-phase motors, 24V motors can be stopped frequently. During an emergency
stop, you should stop the transport units in the area.
When you restart, it is necessary to delay a few seconds the start-up of the motors, in order to
ensure the proper functioning of the stoppers (and positioning units), before to moving the
workpiece carrier on the transfer
No reset by the controller is not necessary for the stoppers and positioning units, repositioning is
done automatically (integrated program component).
I02-244 User & maintenance manual
of
TLM2000 ITS 24 V
Version 03
(translation of the original manual)
Page 2 of 32
Need help?
Do you have a question about the TLM 2000 and is the answer not in the manual?