Frequently Asked Questions - Honeywell E-Mon Class 6200 User Manual

E-Mon® Series Global User Manual
Problem Statement
Suspected faulty reading/
uneven reading available on
the meter/ discrepancies in
the measurement
Meter wiring troubleshooting/
checking wiring before meter
setup.
NOTE
• If the problem cannot be fixed with the steps provided in this section, then
contact local Honeywell E-mon representative or an Authorized Service Center.
•
Do not touch the meter body for troubleshooting as it may cause electrical shock.
•
Check with trained personnel if there is any fault in the reading or the electrical
network.
•
Contact the manufacturer if you suspect a major flaw in the network.
• Do not attempt to open the meter contact points.

10.2. Frequently Asked Questions

Do I need to configure my Class 6200 after installation?
 Yes, it is required to follow one of this option for configuration, or the meter will not
work properly:
•
Meter Display: Setup > Parameters, then go through all settings and select
accordingly (System wiring, Voltage, CS ratio, etc.)
•
App wizard: Just launch your E-Mon Android app and select: "Quickly
commission a meter" or use directly the Parameters or Template menu.
Page | 80
1. Carefully inspect for correct wiring connections as
per set topology.
2. Check the wire connections and correct the wiring
settings if needed.
3. Check the energy meter with a unity device and note
the reading.
4. Involve trained personnel for effectively checking the
meter reading fault.
1. The physical inspection of the wiring and connection
is important before installation. Carefully note the
wiring topology and connection parameters.
2. Check if wiring connections as per set topology are
matching with set System Wiring parameter.
3. The users need to check the wiring for general
verification during the meter setup.
Troubleshooting
Action
54-000-01-ENG01-0121