BYD Energy Pod Series User's Installation And Use Manual page 26

■ Connect the stripped power grid wire into the terminal slot of the corresponding
connector, and tighten the screw (Note: the screw shall be in direct contact with the
wire core, the wire skin cannot be used for fixing, and the wire core exposed outside
the terminal slot shall not exceed 1/2 of the insulation blocking wafer).
A phase mark is arranged at the connector terminal port, as shown in the following
figure; please pay attention to the correspondence during wiring.
Terminal at the end of the grid:
■ Insert the connector already connected with the wire into the Grid interface on the
PCS, and pay attention to the phase correspondence.
4.7.3 Load wiring
■ Refer to the followings for wire stripping schematic diagram and length of load
wires.
Secret
24