BYD Energy Pod Series User's Installation And Use Manual page 23

Secret
■ Installation of BMS and PCS
Install the BMS and PCS in sequence, and insert the wall hanging accessory 1 at the
rear of the BMS into the hole of the wall hanging accessory 2 on the wall
※Note: Each part shall be handled with care during installation, in order to
avoid damage to the components. All parts are fixed by use of M616 bolts,
with a torque of 10N·m.
4.5 System grounding
The system grounding position is shown in the following figure, and
equipped with the M616 bolts.
21