If You Want To Improve Performance; Troubleshooting - SureCall FLAREDB+ User Manual

LED Indicators

IF YOU WANT TO IMPROVE PERFORMANCE

• Identify a location outside that receives a stronger signal and move the outside antenna to that location (higher is usually better).
• Increase the distance between the booster and outside antenna.
• Optimize the angle of your outside antenna by testing at small incremental rotations.
• See more tips and tricks or contact us at https://www.signalbooster.com
If you have any questions during setup, please reach out to our US-based experienced support technicians:
Call: 1-855-846-2654 Visit: https://www.signalbooster.com
Problem
Signal booster has no
power
After installing your signal
booster system, you have
no signal or reception
Booster LED Diagram
10

TROUBLESHOOTING

Resolution
Connect the power supply to an alternate power source.
Be sure the power source is not controlled by a switch that can remove power from the outlet.
Check the POWER LED () on the signal booster. If it is OFF, contact tech support at:
1-855-846-2654
Verify that cable connections are tightly fitted to the booster and antenna.
Try further separating the booster and antenna.
Verify that there is usable signal where the antenna is placed.
Remember: Bars are not always a reliable measure of signal. The best way to confirm signal coverage is the
ability to place and hold a call.
Left LED
https://www.signalbooster.com | 855.846.2654 | order@signalbooster.com
Best
Antenna Position
OK
Power LED
Right LED