Table of Contents
Advertisement
Delayed Egress
Exit Device
Installation Instructions
8
M93 Monitor - Trim Actuated Single Pole Double Throw (SPDT) Switch
Refer to Figure 7 for M93 Monitor - Trim Actuated SPDT Switch wiring.
NOTE:
•
Switch contact rating: 5A @28VDC.
•
Wire must be protected from abrasion.
•
For use with Class II circuits only.
•
For ElectroLynx Hinge Connector System: Follow Section 6 wiring instructions.
•
For non-ElectroLynx door:
Remove connector at end of exit device and connect to incoming wires from power source
using wire nuts, butt splices, etc. See Section 8 for hole locations and sizes.
12 10
1 1 9
Gray
Pink
Tan
See Section 6 for
with 8-Pin Connector
(Wire colors have changed
for M93 monitor only)
Tan (NC), 12
Pink (NO), 11
Gray (C),10
Pigtail Harness
with 4-Pin Connector
(For M93 monitor in combination
with other monitors or functions)
Figure 7
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
See Section 6 for
Wire Layout
Wire Layout
with 8-Pin Connector
(Provided with exit device)
8 6 4 2
7 5 3 1
Pigtail Harness
Raceway Harness with
8 & 4-Pin Connectors
(4-pin connectors are
not shown but are used)
12 10
1 1 9
D Function with M93 Monitor Exit
Device with 4-Pin Connector
Pigtail Harness
4
3
10
Exit Device with
4 & 8-Pin Connectors
1
2
Note: Typical raceway location
is shown. Other locations may
exist depending on door type.
FM209 10/18
Hide quick links:
Advertisement
Table of Contents
