Table of Contents
Advertisement
Delayed Egress
Exit Device
Installation Instructions
9
Non-ElectroLynx Door Prep
Refer to Figure 8 for non-ElectroLynx Door preparation.
NOTE:
•
Do not scale drawing.
•
Dimensions are in inches (") and millimeters (mm).
•
LHR H.M. opening shown. Details are typical for all opening materials (both hands).
•
This preparation is an addition to preparation shown on device template.
•
See device template to locate centerline.
•
Shields for wiring access recommended for insulated and composite doors.
•
Locate and prepare wiring access holes when installing device.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Vertical
Reference
Horizontal
Reference
Exit Device End Clamp Mounting
Holes (For reference only)
Exit Device
Dim. A
ED4000 Series
1-11/16" (43mm)
ED5000 Series
2-5/16" (59mm)
Hinge Edge Detail
INSIDE FACE OF DOOR
Clear Channel Access
Required for Wire
Connection
1" (25mm) Dia.
(Wiring Access)
Horizontal Reference
Device Centerline
(See Note 5)
HINGE EDGE DETAIL
Figure 8
11
Conducting Hinge or
Approved Power Transfer
(made by other manufacturers)
Hinge
5/8" Ref
(16mm)
5/16" Ref
(8mm)
1-1/4" Ref
(32mm)
A
Hinge Edge
Of Door
FM209 10/18
Hide quick links:
Advertisement
Table of Contents
