Water Filter Maintenance; Importing Contact Data; Setting Units; Backup Relay - Henny Penny SpaceSaver Plus Team Service Instructions Manual

5.19 Water filter maintenance

Description This function is available, but cannot be used on this unit.

5.20 Importing contact data

Description Import of service contact data. This data can be accessed by the
Preparing the data Perform according to instructions on the touchscreen.
Importing data

5.21 Setting units

Overview
To convert the units 1. Select the desired temperature and volume.

5.22 Backup relay

Description The control board has a spare relay, which allows alternative use in
Locate defective relay
Occupying the spare relay
operator under "Equipment information".
Create the file "ContactData.txt" with favorite text editor on the
computer.
Open the file on the computer.
Enter contact data distributed over 6 text lines.
Save file on a USB flash drive.
The file must be stored in the folder "FCImport".
Perform according to instructions on the touchscreen.
Touch the Confirmation field.
Import the created contact data.
Then a confirmation appears on the touchscreen.
2. Touch the "OK" field.
case of a relay failure. This is only possible with the listed relays.
Call relay test in the service menu.
Perform relay test. Locate defective relay by examining the
output voltage at the corresponding outputs on the control
circuit board.
Do rewiring according to the table.
Example: When using it for K8 (solenoid M8), rewire line from
connector X17.1 to X12.5.
Service instructions
Service menu - appliance test
33