Error Messages; Safety, Care, Accuracy Test And Disposal; Safety And Protection - Microlife BP W3 Comfort Manual


Always remove the rechargeable batteries if you do not intend
to use the device for a week or more.

Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.

6. Error Messages

If an error occurs during the measurement, the measurement is inter-
rupted and an error message, e.g. «ERR 3», is displayed.
Error Description Potential cause and remedy
«ERR 1» Signal too The pulse signals on the cuff are too weak. Re-
weak position the cuff and repeat the measurement.*
AN
«ERR 2» Error signal During the measurement, error signals were
detected by the cuff, caused for instance by
AO-B
movement or muscle tension. Repeat the
measurement, keeping your arm still.
«ERR 3» No pressure An adequate pressure cannot be generated in
in the cuff the cuff. A leak may have occurred. Check that
AO-C
the cuff is correctly connected and is not too
loose. Replace the batteries if necessary.
Repeat the measurement.
6
Error Description Potential cause and remedy
«ERR 5» Abnormal The measuring signals are inaccurate and no
result result can therefore be displayed. Read through
the checklist for performing reliable measure-
ments and then repeat the measurement.*
«HI» Pulse or cuff The pressure in the cuff is too high (over
pressure too 299 mmHg) OR the pulse is too high (over
high 200 beats per minute). Relax for 5 minutes
and repeat the measurement.*
«LO» Pulse too The pulse is too low (less than 40 beats per
low minute). Repeat the measurement.*
* Please immediately consult your doctor, if this or any other problem
occurs repeatedly.

If you think the results are unusual, please read through the
information in «Section 1.» carefully.

7. Safety, Care, Accuracy Test and Disposal

Safety and protection

 Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device and
keep for future reference.