Edge & Verge Mic Emulations - Antelope Zen Tour Synergy Core User Manual

Edge & Verge mic emulations
Edge & Verge mic emulations are available on preamp/combo inputs 5 – 8. They are intended for use
with the Antelope Audio Edge & Verge modeling microphones only. We cannot guarantee optimal
(or even usable) results with other microphones.
Before attempting to use mic emulations, make sure of the following:
1. The mic emulations for your modeling microphone are installed from the 'Software' tab in the
Antelope Launcher. Install them if they are not.
2. The installed mic emulation bundles are assigned to your Zen Tour Synergy Core.
Getting Started
Mic emulations are accessed by clicking the tiny 'Mic' symbol, seen on Channels 5 – 8 in the
'PREAMPS' tab.
Gain Calibration
It's a good idea to connect your mic(s) now and calibrate preamp gain before you proceed. Click and
turn the Gain knobs or double-click the text fields and enter values from the keyboard.
Gain adjustment for the Edge Solo and Verge is straightforward, but the Edge Duo and Edge Quadro
are multi-membrane microphones. There may be differences in the input signal strength from each
membrane, which may have to be compensated for with individual gain adjustments.
Note that engaging mic emulations for Edge Duo and Edge Quadro automatically 'links' their input
channels, thus individual gain adjustments per input are not possible while using their mic
emulations.
Using Mic Emulations
In the 'Mic Emulations' window, click and rotate the dial to access the emulations available for your
modeling microphone:
Zen Tour Synergy Core User Manual 52