Brain Corp ICE Robotics RS26 Operational Manual page 49

S B
CRUB RUSHES AND
Check the scrub brush/pad for debris, damage, and wear on a daily basis. Remove any excess debris, such as
wire. Scrub brushes or pads should be replaced when they begin to appear thin, are covered with debris, or
are no longer effectively cleaning.
If the machine is equipped with a scrub pad, the pad must be connected to a pad driver. Scrub pads must be
cleaned with soap and water immediately after use, and hung or laid fl at to dry.
R R S
OTATE OR EPLACE CRUB
Use the appropriate brush or pad for the cleaning purpose. Scrub brush pads can be rotated once worn and
replaced once both sides are worn. There are two scrub brushes located below the scrubber driver seat. To
access, rotate, and/or replace the scrubber brush pads or scrubber brushes, the side squeegee assemblies
must be detached fi rst.
Perform the following steps to rotate or replace the scrub brushes/pads:
1. Park the machine on a level, fl at surface.
2. If necessary, press the One-Touch button to raise
the scrub deck.
3. Turn the ignition key to the left (counter-
clockwise) to turn off the machine.
4. Put on appropriate personal protective
equipment if the machine has recently been used.
5. Remove the side squeegee assemblies on both
sides. (See R R
OTATE OR
details.)
6. Push down on the top of the scrub brush/pad to
release it from the scrub deck, then slide it out
from underneath the machine.
7. Rotate or replace:
a. If the machine is equipped with a scrub brush,
replace scrub brush.
b. If the machine is equipped with a scrub pad,
pinch the mounting clip to release, rotate
or replace the scrub pad, and reattach the
plastic mount using the mounting clip.
P
ADS
B /P
RUSHES ADS
S S B
EPLACE IDE QUEEGEE LADES
M
8. Slide the scrub brush/pad underneath the
machine.
9. While pinching the metal tension pins on the top
of the scrub brush/pad driver, push the scrub
brush/pad upward into the sprocket of the scrub
deck assembly until it snaps into place.
for
10. Reattach the side squeegee assembly.
AINTENANCE
V4.0419
• Content Subject to Change
49