Table of Contents
Advertisement
M
AINTENANCE
A
R
S
DJUST
EAR
QUEEGEE
When the scrub deck is lowered, the rear squeegee operates best when adjusted to optimal defl ection height.
The rear squeegee blade should slightly fl are outward when the scrub deck is lowered. Check the squeegee
blade defl ections daily to maintain peak performance.
The optimal defl ection of the side squeegee blades is approximately ½ in (1.25 cm). See below for a guide to
adjusting the side squeegees to optimal defl ection heights.
Optimal Squeegee Defl ection:
½ in (1.25 cm)
Perform the following steps to adjust the defl ection height of the rear squeegee:
1. Park the machine on a level, fl at surface.
2. Press the Vacuum button to lower the rear
squeegee assembly.
3. Turn the ignition key to the left (counter-
clockwise) to turn off the machine.
4. Put on appropriate personal protective
equipment if the machine has recently been used.
5. Locate the two caster wheels located behind the
two middle knobs.
6. Use a 17 mm wrench to remove the locking nut
on each caster wheel.
48
V4.0119
• Content Subject to Change
H
EIGHT
Not Enough Squeegee Defl ection
Too Much Squeegee Defl ection
7. Manually spin the threaded rod to adjust the
caster wheel height. The caster wheel should
touch the ground.
8. When adjusted to the desired height, replace the
locking nut on each caster wheel and tighten.
Advertisement
Table of Contents
