Table of Contents
Advertisement
O
PERATION
ALERT
ROBOT IS OFF PATH
IMPACT DETECTED
MACHINE ERROR
UNKNOWN ERROR
203 TRACTION MOTOR
ERROR
204 BRUSH ERROR
205 VACUUM ERROR
206 SQUEEGEE ERROR
207 SCRUB DECK ERROR
208 NO BRUSH ERROR
BRAKE ERROR
THROTTLE ERROR
32
V4.0119
• Content Subject to Change
CAUSE
Machine is off robotic
route path
Machine bumped
obstacle on cleaning
route
Steering wheel
obstruction
Error(s) of unknown
origin
Acceleration issues
Debris caught in brush
or brush is damaged
Vacuum hose obstructed
or damaged
Squeegee is obstructed,
damaged, or missing
Scrub deck obstruction
is preventing raising/
lowering
Brush missing or
improperly installed
Electronic/mechanical
brake error or issue
Electronic/mechanical
throttle error or issue
RESOLUTION
1. Follow the blue arrow and drive to the red path.
2. When correct, the path will turn white.
3. Press rear BLUE button to start.
1. Make sure the robot's path is clear or drive past any
obstacles.
2. Inspect the robot.
3. If everything is clear, press rear BLUE button to start.
1. Make sure that the steering wheel is free and clear.
2. Press the BLUE button in the back to resume.
1. Turn off and inspect machine.
2. Reboot and attempt to operate.
3. If issue persists, contact customer service.
1. Power off robot.
2. Disconnect then reconnect the battery.
3. Power the robot back on.
4. If issue persists, contact customer service.
1. Inspect brushes/pads for damage of debris. Adjust or
replace as needed.
2. If there are no issues, press the BLUE button on the back to
resume.
3. If issue persists, contact customer service.
1. Inspect vacuum and hose for damage or debris.
2. If the hose is clear, press the BLUE button to resume. If the
hose is broken, call customer service.
1. Inspect squeegee for damage or debris. Adjust or replace as
needed.
2. If there are no issues, press the BLUE button in the back to
resume.
3. Is issue persists, contact customer service.
1. Turn off and inspect machine.
2. If there are no issues, press the BLUE button in the back to
resume.
3. For damage or persistent problems, contact customer
service.
1. Make sure brushes or pads are properly installed.
2. If there are no issues, press the BLUE button in the back to
resume.
3. If issue persists, contact customer service.
Contact Customer Service Immediately.
Contact Customer Service Immediately.
Advertisement
Table of Contents
