Crankcase Side Cover Installation; Oil Seal Installation; Camshaft Installation (Valve Timing Adjustment) - Honda BF2D Series Manual

W O N D A
BFBD
CRANKCASE SIDE COVER INSTALLATION
1)
Clean the mating surfaces of the side cover and the cylin-
der block with a degreasing cleaning agent or a clean
shop towel.
2) Apply the liquid sealant (Three Bond 1216E or equivalent)
to the mating surface of the cylinder block as shown.
3) Install the side cover on the cylinder block.
Be sure to assemble within 3 minutes after application of
the liquid sealant.
4) Loosely install the bolts, then tighten them diagonally in
2 or 3 steps to the specified torque.
Liquid sealant application position
Apply a bead about 1.0 mm (0.04 in) in
TORQUE: 7.5 N-m (0.75 kgf-m, 5.4 Ibf-ftj
5) Wait for 30 minutes after assembly. Do not add oil or
start the engine during this period.
OIL SEAL INSTALLATION:
1) Drive in the oil seal to the specified depth using the special
tools as shown.
DRIVER HANDLE A
ATTACHMENT, 24 x 26 mm
07749
-
001 0000 07746-0010700
2) Apply marine grease to the oil seal lip.
[31 OIL SEAL
2.0
-
2.5 mm
\
(0.08
-
0.10 in)
/
w
141 MARINE GREASE
1
0-4
Page: 48 - Honda BF2D Outboard Motors Shop Manual -
http://www.ReadManuals.Corn
CAMSHAFT INSTALLATION
(Valve timing adjustment)
Install the camshaft by aligning the alignment mark on the
camshaft with the timing mark on the crankshaft.
ALIGNMENT