Breather Valve Installation; Connecting Rod Cap - Honda BF2D Series Manual

HONDA
BFED
BREATHER VALVE INSTALWTION
1) Clean the oil outlet valve, stopper plate and the valve
installation section of the cylinder barrel.
2) Install the valve aligning the positioning projection and
chamfer of the valve with the groove and chamfer of the
cylinder barrel.
3) Install the stopper plate on the valve aligning the chamfered
corner of the stopper plate with the chamfer of the cylinder
barrel.
4) Tighten the 3 mm
screw securely.
CONNECTING ROD CAP
1 1
I
3 mm SCREW
[ 2 1
STOPPER PLATE
1 3 1
OIL OUTLET VALVE
1
MARKS
Install by aligning the alignment marks on the connecting
rod big end and on the cap.
11-3
Page: 54
-
Honda BF2D Outboard Motors Shop Manual - http:llwww.ReadManuals.Com
1 1
I
ALIGNMENT