Clutch Stay Removal And Installation; Clutch Inspection - Honda BF2D Series Manual

CLUTCH STAY REMOVAL
1) Holding the clutch boss with the pin spanner or holding
the flywheel with a commercially available strap wrench,
remove the 8 mm clutch stay bolt.
2) Remove the clutch boss using a commercially available
flywheel puller.
CLUTCH STAY INSTALLATION
1) Clean the crankshaft and clutch stay tapered part of dirt,
oil, grease and other foreign material before installing
the clutch stay.
2) Install the clutch stay onto the crankshaft and install the 8
mm clutch stay bolt.
3) Holding the clutch stay with the pin spanner or holding
the flywheel with a commercially available strap wrench,
tighten the 8 mm clutch stay bolt to the specified torque.
TORQUE: 22.5 N-m (2.25 kgf-m, 16 lbf-ftl
b. INSPECTION
CLUTCH LINING THICKNESS (SC, LC, SCH, LCH
Type only)
Measure the thickness at the center of the lining (with clutch
type only).
D l
CLUTCH STAY
Standard
2.0 mm (0.08 in)
[TzGr]
L 2 1
PIN SPANNER
07702-0020001
Service limit
1.0 mm (0.04 in)
1
111
FLWHEEL PULLER
9-2
Page: 44 - Honda BF2D Outboard Motors Shop Manual - http:llwww.ReadManuals.Com