Ball Bearing 6004 Replacement; Clutch Outer Inspection; Emergency Stop Switch Check - Honda BF2D Series Manual

I) Remove the 42 mm circlip out of the hole in the clutch
outer, and remove the clutch outer.
BALL BEARING 6004 REPLACEMENT
(SC, SCH, LC, LCH type only)
2 1 Remove the bearing using the special tool.
[ - I
111
3) Install the 42 mm circlip on the clutch outer. Install with
the press sagging facing the bearing.
4) Install a new bearing using the special tool.
BEARING SEPARATOR
[ e )
111
,
INNER DRIVER HAN-
DLE, 22 mm
07746-0020100
c. INSPECTION
N
CLUTCH OUTER (SC, SCH, LC, LCH type only)
Measure the clutch outer I.D.
1
Standard
1
Service limit
1
EMERGENCY STOP SWITCH
78.00
-
78.25 mm
(3.071 - 3.081
in)
Check for continuity between the terminals.
There must be no continuity with the clip installed.
There must be continuity when the switch is pushed with
the clip installed.
There must be continuity with the clip removed.
78.5 mm
(3.09 in)
1 3-4
Page: 67 - Honda BF2D Outboard Motors Shop Manual -
http:llwww.ReadManuals.Corn