Clutch Outer Disassembly/Reassembly - Honda BF2D Series Manual

• CLUTCH OUTER
a. DISASSEMBLY/REASSEMBLY
1) Remove the 42.0 mm (1.65 in) internal circlip, and remove the clutch
outer using a press and joint which has 10.0 mm (0.39 in) diameter.
2) Remove the bearing using the 20.0 mm (0.79 in) bearing remover shaft if
it is stuck in the clutch housing, though the bearing is normally remain
in the clutch outer when disassembled.
3) Reassembly will be in the reverse order of disassembly. Install 42.0 mm
(1.65 in) internal circlip and bearing to the clutch outer, then install the
clutch outer to the clutch housing.
4) Make sure to install the 42.0 mm (1.65 in) internal circlip into the groove
on the clutch housing.
HONDA MOTOR CO., LTD.
SERVICE PUBUCATION OFRCE
Page: 76 - Honda BF2D Outboard Motors Shop Manual - http://www.ReadManuals.Com
[s.TooL
I
BEARING REMOVER
07936 - 3710600
07741 - 3710100
07936 - 3710100
's.TooL
I
INNER DRIVER
HANDLE
07746 - 0020100