Flywheel Removal And Installation - Honda BF2D Series Manual

HONDA
BFED
FLYWHEEL REMOVAL
11 Remove the ignition coil.
2) Holding the flywheel with a commercially available strap
wrench] remove the I 0 mm flange nut.
CAUTION
Do not loosen the nut by setting a screw driver or
equivalent tool on the fan blade or projection.
3) Remove the starter pulley.
4) Set a commercially available flywheel puller on the fly-
wheel.
5) Screw in the flywheel puller and remove the flywheel.
CAUTION
Do not try t o remove the flywheel by striking it with
a hammer.
FLYWHEEL INSTALLATION
11 Clean the crankshaft tapered part of dirt, oil, grease and
other foreign material before installing the flywheel.
Be sure that there is no washer and other foreign
material on the magnetic part.
21 Set the woodruff key in the key groove securely.
3) Install the flywheel over the crankshaft.
4 1 Align the projection on the starter pulley with the cutout
in the flywheel, and install the pulley.
5 1 Apply light coat of the oil to the threads and seating sur-
face of the 10 mm flange nut, and loosely tighten the nut.
Holding the flywheel with a commercially available strap
wrench, tighten the I 0 mm flange nut to the specified
torque.
TORQUE: 27.5 N-m (2.75 kgf-ml 20 lbf-ftl
6) Install the ignition coil and adjust the air gap. (P. 8-31.
111 STRAP WRENCH
(Commercially available)
\
[I
I
FLWHEEL PULLER
(Commercially availa
111
121
PROJECTION STARTER
PULLEY
141 131
CUTOUT FLYWHEEL
[I
I
STRAP WRENCH
(Commercially available)
\
Page: 41 - Honda BF2D Outboard Motors Shop Manual - http:llwww.ReadManuals.Com