Fan Cover Removal And Installation - Honda BF2D Series Manual

5. RECOIL STARTER/FAN COVER
:HONDA.
BF2D
I
1. FAN COVER 2. RECOIL STARTER
1. FAN COVER
8.
REMOVAL/INSTALLATION
') Remove the engine cover (P. 4-').
2) Remove the fuel tank (P. 4-2).
3) Remove the spark plug cap.
4) Disconnect the engine switch wire.
[8J
RECOIL STARTER
DISASSEMBLY: P. 5-2
REASSEMBLY: P. 5-2
[7J FAN COVER
REASSEMBLY:
Align the hole in the cover
with the boss on the engine
under case and align the
groove in the cover with the
engine under case securely.
[6] ENGINE SWITCH WIRE
[5J HIGH TENSION WIRE
5x 12
[2J
THROTTLE CABLE HOLDER PLATE
REASSEMBLY:
Align the throttle wire with the
groove in the case as shown,
and secure with the throttle
cable holder.
[2J-1
THROTTLE
CABLE HOLDER
PLATE
[3J GROMMET
REASSEMBLY:
Pass the stop switch wire and
the high tension cord as
shown. [3]-1
HIGH TENSION
CORD
~
[3J-2
STOP SWITCH
WIRE
[4J IGNITION COIL PRIMARY WIRE
REASSEMBLY:
Connect to the emergency stop
switch wire connector then set
them in the groove of the fan
cover as shown.
~
[4]-1
GROOVE
5-1
Page: 31 - Honda BF2D Outboard Motors Shop Manual - http://www.ReadManuals.Com