Flying; Flying An Array With K3-Bump And K3-Bar - L-Acoustics K Series Owner's Manual

Flying

Flying an array with K3-BUMP and K3-BAR

Type of deployment
Rigging accessory
Min number of operators
Prerequisite
Preset inter-enclosure angles
Preset the inter-enclosure angles before performing this procedure. Refer to
(p.65).
Procedure
1. Prepare a block of K3 enclosures. Refer to
2. Connect K3-BAR to K3-BUMP.
a) Remove the pins from K3-BAR and position K3-BAR on K3-BUMP.
Refer to Soundvision to identify the extension and position of the bar.
K3 owner's manual (EN) version 1.0
own array
K3-BUMP
2 × Ø19 mm shackles WLL 3.25 t (provided)
K3-BAR
2
Preparing a block of four K3
Pre-setting the inter-enclosure angles
(p.61).
Rigging procedures
67