L-Acoustics KIVA Manual

Securing arrays with kiva-pullback for permanent installation

Hide thumbs Also See for KIVA:

Introduction

From the version 3.1.2 of Soundvision, Kiva / Kiva II congurations trigger an orange (intermediate) warning when

the load is between 200 kg and 300 kg at the rear linking points. In this case, a mechanical warning appears in the

Mechanics View window.

In permanent installation, these congurations must be secured with a KIVA-PULLBACK as described in this document.

In touring application, this warning can be ignored.

Instructions

Inspect the system before any deployment.

Perform safety related checks and inspections before any deployment.

Perform preventive maintenance at least once a year.

Refer to the preventive maintenance section in the user documentation for a list of actions and their periodicity.

Insufcient upkeep of the product can void the warranty.

If any safety issue is detected during inspection, do not use the product before performing

corrective maintenance.

Check for issues. A rigging system part or fastener is missing or loose. A rigging system part exhibits: bends,

breaks, broken parts, corrosion, cracks, cracks in welded joints, deformation, denting, wear, holes. A safety cue

or label is missing. A loose part is not adequately secured.

Work with qualied personnel for rigging the system

Installation should only be carried out by qualied personnel that are familiar with the rigging techniques and

safety recommendations outlined in this manual.

Securing Kiva / Kiva II arrays with KIVA-PULLBACK for permanent installation technical bulletin (EN) version 1.0

PERMANENT INSTALLATION

technical bulletin - v.1.0

Table of Contents

Do you have a question about the KIVA and is the answer not in the manual?

Page 1 Introduction From the version 3.1.2 of Soundvision, Kiva / Kiva II congurations trigger an orange (intermediate) warning when the load is between 200 kg and 300 kg at the rear linking points. In this case, a mechanical warning appears in the Mechanics View window.
Page 2 This symbol noties the user about instructions that must be strictly followed to ensure proper installation or operation of the product. This symbol noties the user about complementary information or optional instructions. Securing Kiva / Kiva II arrays with KIVA-PULLBACK for permanent installation technical bulletin (EN) version 1.0...
Page 3 WLL of 300 kg. Procedure 1. Set up the array. Refer to the rigging procedures of the Kiva rigging manual or of the Kiva II owner's manual. 2. Lower the array. 3. Secure a KIVA-PULLBACK under the bottom enclosure.
Page 4 Do not apply overtension on the wire rope Tense it so that the wire rope is not slack. 8. Raise the array. KIBU-SB KIBU / KIBU II Securing Kiva / Kiva II arrays with KIVA-PULLBACK for permanent installation technical bulletin (EN) version 1.0...

Kiva ii