Redundant System Settings - Mitsubishi Electric MELSEC iQ-R Series User Manual

If the transfer target network module is on a network other than MELSECNET/H network, set the transfer
destination link devices within the own station send range of the network module. If the link devices are set
within the send range of another station, the transferred data are overwritten with the send data of another
station.
Control station (station No.1)
0
·

Redundant System Settings

Set the operation mode for the RJ71LP21-25 mounted on system B in a redundant system.
Item
Station No. (System A)
Module Operation Mode
(System A)
Station No. (System B)
Module Operation Mode
(System B)
For the parameter errors that occur in the redundant CPU, refer to the following.
 MELSEC iQ-R CPU Module User's Manual (Application)
2 PARAMETER SETTINGS
78
2.4 Application Settings
LB
...
0 3F
...
1000 103F
Description
Displays the station number set in "Station No." under "Required Settings".
Displays the module operation mode set for "Module Operation Mode" under "Application
Settings".
Displays the station number of system B.
Set the module operation mode of system B.
For details on the module operation mode, refer to the following.
Page 73 Module Operation Mode
Network module
RX
0
Set transfer destination link
device within own station send
range of the network module.
1000
·
Own station send range
Other station send range
Setting range



• Online
• Debug Mode
• Offline
• Forward Loop Test
• Reverse Loop Test
• Test between Master Station
• Test between Slave Station
• Self-loopback Test
• Internal Self-loopback Test
• Hardware test
(Default: Online)