Status Indication; Diagnostics Capabilities By Means Of Status Indication - Jetter JX3-BN-EC User Manual

Jetter AG

3.3 Status indication

R E D1 D2
EC RUN
EC ERR
Fig. 2: Status indication

3.3.1 Diagnostics capabilities by means of status indication

JX3-BN-EC User Manual
LEDs indicate the communication status of the device as well as the status of the
power supply.
LEDs Description
R Logic circuit supply
E Communication with the
controller
®
EC EtherCAT operating state
RUN
The color and status of the LEDs provide diagnostic options for various states. In
the JetSym application software, diagnostics can be performed in the hardware
manager or via the setup window by entering the corresponding register number.
LEDs Status
R OFF
ON
E OFF
ON
D1 ON
D2 ON
D2 Blinking at
1 Hz
D2 Blinking at
4 Hz
EC RUN OFF
Blinking
Blinking 1
time
ON
Flickering
EC ERR ON
2 flashes
1 flash
Blinking
Flickering
OFF
LEDs
D1
D2
EC
ERR
Color Description
--- Power supply or operating system error
Green OS is running
--- Normal operating condition
Red Generic error
Red Special states
Red Boot loader is being executed
Red Operating system of the peripheral module is
being updated
Red Operating system of JX3-BN-EC is being
updated
--- The device is in INITIALIZATION state
Green The device is in PREOPERATIONAL state
Green The device is in SAFEOPERATIONAL state
Green The device is in OPERATIONAL state
Green The device is booting and is in BOOTSTRAP
mode (firmware is being loaded)
Red Critical communication or application error
Red Timeout of process data/EtherCAT
Red The EtherCAT
dently by the JX3-BN-EC due to a local error.
Red General configuration error
Red Booting error
®
--- EtherCAT communication of the device is
ready for operation
Product description | 3
Description
Hardware errors
Operating system
®
EtherCAT error state
®
®
state was changed indepen-
watchdog
9 / 92