Table of Contents
Advertisement
Jetter AG
5 Mechanical installation
5.1 Installing the device on the DIN rail
NOTICE
JX3-BN-EC User Manual
This chapter describes how to install and replace the JX3-BN-EC.
Functional impairment caused by unfavorable installation
►
Install the device only in vertical position on the DIN rail (DIN EN 60715).
►
Keep the minimum distance to surrounding parts.
3
Fig. 5: Installing the device on the DIN rail
DIN rail
1
Minimum distance to surrounding parts = 30 mm
3
1.
Disconnect the system from the power supply.
2.
Place the upper latch (2) in angled position on the DIN rail (1).
3.
Snap the lower latch of the device onto the lower edge of the DIN rail.
4.
Slide the device to its intended position.
3
1
2
Mechanical installation | 5
2
Upper latch
15 / 92
Advertisement
Table of Contents
