Table of Contents
Advertisement
Jetter AG
5.3 Dismounting the enclosure from the backplane module
NOTICE
JX3-BN-EC User Manual
The upper and lower backplane tab on the module let you pull off the enclosure
from the backplane module.
Mechanical damage and limited immunity to interferences
When replacing devices, degree of protection IP20 is not guaranteed. If you
touch the EMC clip, you may damage this clip. A damaged clip may result in
lower noise immunity.
►
Do not touch any electronic components once the enclosure has been re-
moved from the backplane module.
A
Fig. 7: Dismounting the enclosure from the backplane module
DIN rail latch
1
1.
Disconnect the system from the power supply.
2.
Press the upper and lower latches (1) on the device simultaneously.
3.
Keep the latches pressed and pull off the enclosure.
Mechanical installation | 5
A
1
1
Detail view
A
17 / 92
Advertisement
Table of Contents
