Place The Camera, Display, And Computer; Connect The Camera To Flir Screen Est; Get Familiar With The Screening - FLIR E Series User Manual

5
Setting up the screening station

5.7 Place the camera, display, and computer

Place the visitor display and the camera at the screening station.
1. Mount the display and camera. The camera shall be placed under the display.
2. Define the screening position: Make a straight line from the camera towards the
screening position - use a masking tape. Make a mark on the tape at 1–2 m (3–6 ft.)
from the camera, indicating the screening position.
3. Place the backdrop behind the screening position.
4. Tilt the camera upwards, so that the lens aims at the head of a person standing at the
screening position. The angle can be adjusted later, when testing the system.
Place the computer where you want to keep it for easy operator access.
1. Connect the visitor display to the computer.
2. Connect the camera to the computer using the USB cable with power adapter, see
section 5.6.2 Connect the camera to the computer.
3. Connect the USB cable power adapter to a power outlet.
4. Change the computer screen setting so the visitor display acts as an extension to the
computer screen.
Figure 5.1 Typical screening station setup
1. Computer
2. Stand
3. Display
4. Thermal camera
5. Screening position
6. Backdrop

5.8 Connect the camera to FLIR Screen EST

1. Turn on the camera, by pushing the on/off button
2. In the FLIR Screen EST operator window, go to the Live page.
3. In the Discovery pane, make sure Dual is selected.
4. In the Discovery pane, click the button to the right to connect to the camera.

5.9 Get familiar with the screening

Note See also section 5.5.3 Working principle.
1. Place a person in front of the camera.
#T810558; r. AB/67023/67023; en-US
.
14