Final Setup And Checkout - S&C GridMaster Installation Manual

Installation

Final Setup and Checkout

Before switching on and configuring the GridMaster
Microgrid Control System according to the instructions
in S&C Instruction Sheet 1025-530, check the following:
Make sure the GridMaster controller is securely
STEP 1.
installed in the enclosure. Check all fasteners
for tightness.
Make sure all cable connections and wiring
STEP 2.
connections to the GridMaster controller are
secure. If the controller is connected to a swing-
out panel, make sure the cables are trained and/
or harnessed so movement of the panel will not
loosen the connection.
Turn on the control power to the GridMaster
STEP 3.
controller by toggling the ON switch in the
upper right-hand corner of the control to the On
position. The power indicator will illuminate.
STEP 4. Open a browser window and connect to the
network to which the controller is connected.
Connect to the controller by entering the
address and log-in credentials securely supplied
to you by S&C Electric Company. Detailed log-in
and password-maintenance information can be
found in S&C Instruction Sheet 1025-530.
When logged in to the control, check the
functioning of the intrusion-detection system (if
installed) by opening and closing the enclosure
door. When open, the door alarm will appear in
a pop-up window. See Figure 10.
Figure 10. The GridMaster Microgrid Control System door alarm pop-up.
14
S&C Instruction Sheet 1025-510