Connecting The Power Cable; Turning On And Off This Unit - Yamaha RX-V2600 Owner's Manual

CONNECTIONS

Connecting the power cable

■ Connecting the AC power cable
Plug the supplied AC power cable into the AC inlet after
all other connections are complete and then plug the AC
power cable to an AC wall outlet.
CAUTION
Use the supplied AC cable. Do not use other AC power cables as
doing so may result in fire hazard or electrical shock.
AC IN
AC OUTLETS
SWITCHED
50W MAX.TOTAL
(General model)
AC OUTLET(S) (SWITCHED)
U.K. and Australia models .................................... 1 outlet
Korea model ...............................................................None
Other models .........................................................2 outlets
Use these outlets to supply power to any connected
components. Connect the AC power cables of your other
components to these outlets. Power to these outlets is
supplied when the main room, Zone 2 or Zone 3 is turned
on. However, power to these outlets is cut off when the
main room, Zone 2 and Zone 3 are turned off or when
MASTER ON/OFF on the front panel is pressed and
released outward to the OFF position. The maximum
power or the total power consumption of the components
that can be connected to these outlets is as follows.
Asia and General models........................................... 50 W
Other models ...........................................................100 W
VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE plugging
into the AC main supply. Voltages are as follows:
Asia model............................AC 220/230–240V, 50/60 Hz
General model ...... AC 110/120/220/230–240 V, 50/60 Hz
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost
in case the power cord is disconnected from the AC
wall outlet for more than one week.
30

Turning on and off this unit

When all connections are complete, turn on the power of
this unit.
2,3
AUDIO MULTI CH
SELECT INPUT A/B/C/D/E
MAIN ZONE INPUT
SOURCE/ SPEAKERS
REMOTE
DVD MD/TAPE
DTV CD-R
A B
CBL/SAT CD
VCR 1 PHONO YPAO SILENT CINEMA
ON/OFF
DVR/
TUNER
VCR 2
V-AUX
REC OUT/ZONE 2 OPTIMIZER
MASTER MIC PHONES
ON OFF
1,4
1
Press MASTER ON/OFF on the front panel
inward to the ON position to turn on the
power of this unit.
• Only this unit is turned on.
• Zone 2 and Zone 3 are set to the standby mode.
ON
2
Press MAIN ZONE ON/OFF on the front panel
(or STANDBY on the remote control) to set
this unit to the standby mode.
ON/OFF
Front panel
PURE DIRECT
VOLUME
PRESET/ PRESET/ TUNING TONE
TUNING TUNING FM/AM MEMORY MODE STRAIGHT CONTROL
EDIT MAN'L/AUTO FM AUTO/MAN'L EFFECT
ZONE ON/OFF ZONE CONTROL
PROGRAM
MULTI ZONE
ZONE 2 ZONE 3
S VIDEO VIDEO L AUDIO R OPTICAL
VIDEO/AUX
MASTER
OFF
STANDBY
or
Remote control