Yamaha RX-V2600 Owner's Manual page 38

AUTO SETUP
After all menu items have been measured, "Measurement
Over" appears on the screen and the results for each item
are displayed.
• Press n and select Setup to set the measured values.
• Press k and select Retry to retry the AUTO SETUP
procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see
TROUBLESHOOTING page 119.
• Press l and select Exit to exit from the AUTO SETUP
procedure. If you select Exit, "Don't Setup?" appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
y
• If you want to make more detailed settings, change the system
parameters using the Manual Setup menu. If you want to return
to the Auto Setup settings after making settings in the Manual
Setup menu, navigate to the Information screen in the Auto
Setup menu, press k / n repeatedly to select the parameter you
want to adjust and then press ENTER.
• If you are not satisfied with the result or want to manually
adjust each step parameter, THX recommends running the
Manual Setup (see page 76).
Notes
• If you change speakers, speaker positions, or the layout of your
listening environment, perform AUTO SETUP again to re-
calibrate your system.
• Depending on your listening environment, SubWfr:REV may
appear in the Wiring results. In this case, SWFR Phase in the
Manual Setup menu (see page 85) is automatically set to
Reverse. To select the desired setting, change the SWFR Phase
parameter in the Manual Setup menu.
• In the Distance results, the distance displayed may be longer
than the actual distance depending on the characteristics of your
subwoofer. This may also be the case when using an external
amplifier.
• In the Equalizing results, different values may be set for the
same band to provide finer adjustments.
36