Yamaha RX-V2600 Owner's Manual page 101

Setting remote control AMP codes
Select one of the following codes to set the remote control
AMP code for the component you want to use.
Set AMP/SOURCE/TV to AMP or SOURCE and then
change the remote control code settings.
AMP library
code
Function
(remote
control
setting)
To operate this unit using
2001 the default code.
(initial setting) To operate Zone 2 or Zone 3
features (see page 108).
To operate this unit using an
alternative code.
2002
To operate Zone 2 or Zone 3
features (see page 108).
Notes
• You need to set the corresponding remote control AMP ID
(see page 95).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
Setting remote control tuner codes
Select one of the following codes to set the remote control
tuner code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press TUNER
on the remote control to select TUNER as the input source
and then change the remote control code settings.
Tuner
library code
Function
(remote
control
setting)
2602 To operate this unit using
(initial setting) the default code.
To operate this unit using an
2603
alternative code.
Notes
• You need to set the corresponding remote control tuner ID
(see page 95).
• When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
5
Press ENTER.
The four-digit code set for the selected component
appears in the display window.
Note
Remote
0000 appears in the display window if no code has been set.
control
AMP ID
(this
6
Press the numeric buttons to enter the
unit's setting:
see page 95)
four-digit remote control code for the
component you want to use.
ID1
For a complete list of available remote control codes,
(initial setting)
refer to "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
ID2
7
Press ENTER to set the number.
OK appears in the display window if setting was
successful.
NG appears in the display window if the setting was
unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button or
SELECT k / n to select the component and then repeat
steps 4 through 6.
8
Press LEARN again to exit from the setup
mode.
Remote
LEARN
control
tuner ID
(this unit's
setting:
see page 95)
ID1
(initial setting)
ID2
REMOTE CONTROL FEATURES
STEREO MUSIC ENTERTAIN MOVIE
1 2 3 4
THX
STANDARD SELECT EXTD SUR.
5 6 7 8
1 MEMORY 2 A SPEAKERS B
9 0 +10
ENT.
99