Yamaha RX-V2600 Owner's Manual page 121

Yamaha av receiver owner's manual
Hide thumbs Also See for RX-V2600:
Table of Contents

Advertisement

■ AUTO SETUP
Before AUTO SETUP
Error message
Connect MIC!
Optimizer microphone is not connected.
Unplug Phones!
Headphones are connected.
No Setup Menu!
No setup menu items have been selected.
Memory Guard!
This setting is protected.
During AUTO SETUP
Error message
Front L/R channel signal(s) is (are) not
E01:No Front SP
detected.
E02:No Surr. SP
A surround channel signal is not detected.
E03:No PRNS SP
A presence channel signal is not detected.
Only right surround back channel signal is
E04:SBR–>SBL
detected.
E05:Noisy
Background noise is too loud.
Surround back speaker(s) is (are)
E06:Check Surr.
connected, though surround L/R speakers
are not.
The optimizer microphone was unplugged
E07:No MIC
during the AUTO SETUP procedure.
The optimizer microphone does not detect
E08:No Signal
test tones.
The AUTO SETUP procedure was
E09:User Cancel
cancelled due to user activity.
E10:Internal Err
An internal error occurred.
Cause
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug the headphones.
Select at least one setup menu item.
Remove the protection setting for AUTO SETUP.
Cause
Select the front speakers by pressing SPEAKER A or
B on the front panel (or by setting AMP/SOURCE/
TV to AMP and then pressing SPEAKER A or B on
the remote control).
Check the front L/R speaker connections.
Check the surround speaker connections.
Check the presence speaker connections.
Connect the surround back speaker to the LEFT
SURROUND BACK SPEAKERS terminal if you
only have one surround back speaker.
Try running AUTO SETUP in a quiet environment.
Turn off noisy electric equipment like air conditioners
or move them away from the optimizer microphone.
Connect surround speakers when you use (a)
surround back speaker(s).
Connect the supplied optimizer microphone to
OPTIMIZER MIC jack on the front panel.
Check the microphone setting.
Check the speaker connections and placement.
Run AUTO SETUP again.
Run AUTO SETUP again.
TROUBLESHOOTING
Remedy
Remedy
See
page
32
91
See
page
15
15
15
15
15
32
32
15
32
32
119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents