Sample Software - Renesas R-IN32M3 Quick Start Manual

R-IN32M3 Module Quick Start Guide

4. Sample Software

4.1 PROFINET Sample Application (01_pnio_io_mirror)
Start the example "01_pnio_io_mirror" according to the previous description.
To establish a PROFINET communication, the R-IN32M3 Module must be selected in [Network Navigator].
Then, select the [PNIO Master] function panel. Use [Scan device] to detect the PROFINET device.
Figure 4.1 PROFINET Master
Use the "Wink" command to identify the connected R-IN32M3 Module, which will be shown with a flashing
"LED1" on the R-IN32M3 Module board.
To establish a cyclic PROFINET communication, use the I/O panel of the PNIO Master.
Figure 4.2 PNIO Master I/O
To continue, load the GSDML file provided with the distribution of the Renesas sample application.
In the selector [Device Access Point], select "2-port Device".
After that, press the [Connect] button. This button starts cyclic PROFINET communications.
R12QS0043ED0100 Page 20 of 24
Aug 03, 2020