Delta Computer Systems TMC 188/40 Series Manual page 72

Appendix A: Maps, Tips, and Commands
Alt C Clear event(s) on module
Alt E Set event(s) on module
Alt K Kill events
Alt M Update event(s) mask
register on module
Alt Q Quit events
Ctrl S Save events steps to disk
Spreadsheet Edit Keys
End, Home, Move cursor
Shift Highlight text
Ctrl C Copy highlighted text
Ctrl X Cut highlighted text
Ctrl V Paste buffered text
Ctrl G Move to next event step
Ctrl R Read events steps from disk
Ctrl W Set field width (TMC
VMemory editor)
Esc Exit to main screen
text Enter text to fill
highlighted cells
Special Functions
Ctrl P Edit motion profiles (MMC)
Ctrl T Toggle readback mode
Ctrl W Edit V memory (TMC)
P0, P1 Scale, offset, direction,
extend, and retract
calculation
Alt F Auto feedforward adjust
Using the Demo Features
F1-F10 Move using predetermined
positions
Alt F1-F10 Move and generate a datalog
(RADISYS, SBS, and
ZYCOM only)
Alt A Toggle Auto move - when
on, DCSMON cycles
through Automove file
Ctrl A Edit Automove file using
Table Editor
Ctrl F Edit F1-F10 keys using
Table Editor
Ctrl F1-F10 Move using predetermined
positions and profiles
72
TMC 188/40 Motion Control Module
Viewing Configurations
Ctrl C View system configuration
Ctrl E Call editor to configure
DCSMON
DOS Command Line Options
Syntax: DCSMON [opt 1] [opt 2]...
... [opt n]<CR>
opt 1 Initialization file; the default is
DCSMON.INI. Do not enter the file
extension (.INI).
opt 2 Project filename specification; the
default is DCSMON.BD1. Enter only if
an initialization file has been entered
as opt 1, and do not enter the file
extension (.BDn).
If DCSMON is started with no options
specified, the default files are used.
Other options are:
/D Created a debug file (debug.txt)
with a history of all commands
executed from DCSMON
/F Forces initialization of the module
when DCSMON starts
/L Starts DCSMON in look-only mode
/R Starts DCSMON in read mode
/W Starts DCSMON in write mode
The „/‟ can also be a „-‟. These options can all
be specified in the .ini file, but when specified
on the command line they supersede the .ini
file.
Delta Computer Systems, Inc. 360/254-8688