After Operation; After Operation Safety; Hauling The Machine - Toro Workman MDX-D Operator's Manual

Important:
Loss of steering control or the
machine may tip over if you position the
load behind the rear axle and the traction
on the front tires is reduced.
•
Use extra caution when transporting oversized
loads in the cargo bed, particularly when you
cannot center the weight of the oversize load to
the cargo bed.
•
Whenever possible, secure the load by binding it
to the cargo bed so that it does not shift.
•
When transporting liquid in a large tank (such
as a sprayer tank), use caution when driving
the machine uphill or downhill, when suddenly
changing speed or stopping, or when driving over
tough surfaces.
The capacity of the cargo box is 0.37 m
The amount (volume) of material that you can place
in the bed without exceeding the load ratings of the
machine can vary greatly depending on the density
of the material.
Refer to the following table for load volume limits with
various materials:
Material
Gravel, dry 1522 kg/m
Gravel, wet 1922 kg/m
Sand, dry 1442 kg/m
Sand, wet 1922 kg/m
Wood 721 kg/m
Bark
<721 kg/m
Earth, packed 1602 kg/m
3 (13 ft
Density Maximum Cargo
Box Capacity
(on level ground)
3 (95 Full
lb/ft 3 )
3 (120 3/4 Full
lb/ft 3 )
3 (90 Full
lb/ft 3 )
3 (120 3/4 Full
lb/ft 3 )
3 (45 lb/ft 3 ) Full
Full
3 (<45
lb/ft 3 )
3 (100 3/4 Full
lb/ft 3 ) (approximately)

After Operation

After Operation Safety

General Safety
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Shift the transmission to the N
– Engage the parking brake.
– Lower the cargo bed.
– Shut off the machine and remove the key.
3 ).
– Wait for all movement to stop
•
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Do not store the machine where there is an open
flame, spark, or pilot light, such as on a water
heater or other appliance.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Maintain and clean the seat belt(s) as necessary.
•
Replace all worn, damaged, or missing decals.

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Refer to Figure 17
locations on the machine.
Note:
Load the machine on the trailer with the front
of the machine facing forward. If that is not possible,
secure the machine hood to the frame with a strap,
or remove the hood and transport and secure it
separately or the hood may blow off during transport.
CAUTION
Loose seats may fall off the machine and
trailer when transporting the machine, and
the seats may land on another machine or
obstruct the roadway.
Remove the seats or make sure that the seats
are securely fastened to the coupling in the
seat shroud.
21
EUTRAL
and Figure 18 for the tie-down
position.