After Operation; After Operation Safety - Toro 07383 Operator's Manual

Troubleshooting the Hydraulic
Control
•
Difficulty in connecting or disconnecting quick
couplers.
The pressure is not relieved (the quick coupler is
under pressure).
•
The power steering is turning with great
difficulty or it is not turning at all.
– The hydraulic-fluid level is low.
– The hydraulic-fluid temperature is too hot.
– The pump is not operating.
•
There are hydraulic leaks.
– The fittings are loose.
– The fitting is missing the O-ring.
•
An attachment does not function.
– The quick couplers are not fully engaged.
– The quick couplers are interchanged.
•
There is a squealing noise.
– Remove the valve left in the O
causing hydraulic fluid to flow over the relief
valve.
– The belt is loose.
•
The engine does not start.
The hydraulic lever is locked in the F
position.

After Operation

After Operation Safety

General Safety
•
•
•
•
position detent,
N
•
•
ORWARD
28
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Shift the transmission to the N
– Engage the parking brake.
– Lower the cargo bed.
– Shut off the machine and remove the key.
– Wait for all movement to stop
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
Do not store the machine where there is an open
flame, spark, or pilot light, such as on a water
heater or other appliance.
Keep all parts of the machine in good working
condition and all hardware tightened.
Maintain and clean the seat belt(s) as necessary.
Replace all worn, damaged, or missing decals.
position.
EUTRAL