Chassis Maintenance
Adjusting the Cargo-Bed
Latches
If the cargo-bed latch is out of adjustment, the cargo
bed vibrates up and down as you drive the machine.
You can adjust the latch posts to make the latches
hold the cargo bed snugly to the chassis.
1.
Loosen the locknut on the end of the latch post
(Figure
58).
Figure 58
1. Latch
2. Locknut
2.
Rotate the latch post clockwise until it is snug
against the hook portion of the latch
3.
Torque the locknut to 19.7 to 25.4 N∙m (175 to
225 in-lb).
4.
Repeat this steps
the other side of the machine.
3. Latch post
(Figure
1
through
3
for the latch on
Cleaning
Washing the Machine
Service Interval: Before each use or daily—Wash
Wash the machine as needed using water alone
or with a mild detergent. You may use a rag when
washing the machine.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Important:
Do not use power-washing equipment
to wash the machine. Power-washing equipment
may damage the electrical system, loosen
important decals, or wash away necessary grease
at friction points. Avoid excessive use of water
near the control panel, engine, and battery.
Important:
Do not wash the machine with the
engine running. Washing the machine with the
engine running may result in internal engine
damage.
g002181
58).
47
the machine.