Table of Contents
Advertisement
After Operation
After Operation Safety
General Safety
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Move the direction selector to the N
position.
– Engage the parking brake.
– Shut off the machine and remove the key.
– Wait for all movement to stop.
•
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Do not store the machine where there is an open
flame, spark, or pilot light, such as on a water
heater or other appliance.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Maintain and clean the seat belt(s) as necessary.
•
Replace all worn, damaged, or missing decals.
Battery and Charger Safety
General
•
Use only the supplied power cord for battery
charging.
•
Confirm the voltage that is available in your
country before using the charger.
•
For connection to a supply not in the US,
use an attachment plug adapter of the proper
configuration for the power outlet, if needed.
•
Do not charge the machine in rain or wet
conditions.
•
A risk of fire, electric shock, or injury may result
from using an accessory not recommended or
sold by Toro.
•
To reduce risk of a battery explosion, follow these
instructions and the instructions for any equipment
that you intend to use near the charger.
•
Do not open batteries.
•
In the event that a battery leaks, avoid contact with
the liquid. If you accidentally come into contact
with the liquid, flush with water and seek medical
help. Liquid ejected from the battery may cause
irritation or burns.
•
Refer to an authorized Toro distributor to service
or replace a battery.
Training
•
Never allow children or untrained people to
operate or charge the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Read, understand, and follow all instructions on
charging the machine.
Preparation
EUTRAL
•
Keep bystanders and children away while
charging.
•
Wear appropriate clothing while charging,
including eye protection; long pants; and
substantial, slip-resistant footwear.
•
Shut off the machine and wait 5 seconds until the
machine has completely powered down before
charging. Failure to do this may cause arcing.
•
Ensure that the area is well ventilated while
charging.
•
Read and follow all precautions for charging.
•
The charger is for use only on nominal 100 to 240
VAC circuits, and is equipped with a grounding
plug for 120 VAC operation. For use with 240 V
circuits, contact your authorized Toro distributor for
the correct power cord.
•
Use only a power cord approved by Toro.
Operation
•
Do not abuse the power supply cord or yank on
it to disconnect the charger from the receptacle.
Keep the cord from heat, oil, and sharp edges.
•
Connect the charger directly to a grounding
receptacle. Do not charge on an ungrounded
outlet, even with an adaptor.
•
Do not alter the provided power cord or plug.
•
Avoid dropping a metal tool near or onto a battery;
it might cause a spark or short-circuit an electrical
part that could lead to an explosion.
•
Remove metal items such as rings, bracelets,
necklaces, and watches when working with a
lithium-ion battery. A lithium-ion battery can
produce enough current to cause a severe burn.
•
Use an appropriate extension cord.
•
If the power supply cord is damaged while it
is plugged in, disconnect the cord from the
wall receptacle and contact an authorized Toro
distributor for a replacement.
•
Unplug the charger from the electrical outlet when
not in use, before moving it to another location, or
prior to servicing it.
23
Advertisement
Table of Contents
