Replacing The Fuses; Maintaining The Headlights - Toro Workman MDX-D Operator's Manual

Replacing the Fuses

There are 7 fuses in the electrical system. They are
located beneath the hood
Alarm/Power Point
Engine
Headlights
Machine fuse
Lift
Rear lift
Horn
Figure 37
1. Fuse block

Maintaining the Headlights

Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the
system is designed for, you may damage the
12 V power supply, or at a minimum, blow the
fuse.
Always use the specified Toro LED bulb to
prevent this issue.
(Figure 37).
2. Ground block
CAUTION
The bulbs become extremely hot when in
operation. Handling a hot bulb can cause
severe burns and personal injury.
10 A
Always allow enough time to for the bulbs
10 A
to cool before replacing them. Use care
10 A
whenever handling the bulbs.
15 A
Specification: See your Parts Catalog.
15 A
15 A 1. Disconnect the battery; refer to
the Battery (page
30 A
2. Open the hood.
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly at the back of the headlight housing
(Figure 38).
g036871
1. Headlight housing
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn
counterclockwise and moving it rearward,
out of the headlight housing
5. Insert the new lamp assembly and headlight
housing and align the tabs in the lamp assembly
with the slots in the headlight housing
38).
6. Secure lamp assembly by turning it 1/4 turn
clockwise
7. Connect the electrical connector for the harness
to the connector of the new lamp assembly
(Figure 38).
8. Connect the battery and close the hood; refer to
Connecting the Battery (page
36
Disconnecting
34).
Figure 38
3. Harness-electrical
connector
(Figure
(Figure 38).
35).
g036872
38).
(Figure