Controls - Toro Workman MDX-D Operator's Manual

Controls

Control Panel
1. Steering wheel
2. Cup holder
3. Passenger handhold
4. Brake pedal
Accelerator Pedal
Use the accelerator pedal
ground speed of the machine. Pressing down the
accelerator pedal starts the engine. Pressing the
pedal farther increases the ground speed. Releasing
the pedal slows the machine, and the engine shuts off.
Note:
The maximum forward speed is 26 km/h
(16 mph).
Brake Pedal
Use the brake pedal to stop or slow the machine
(Figure 7).
CAUTION
Operating a machine with worn or incorrectly
adjusted brakes can may result in personal
injury.
If the brake pedal travels to within 25 mm (1
inch) of the machine floor board, adjust or
repair the brakes.
Figure 7
5. Accelerator pedal
6. Parking-brake handle
(center console)
7. Operator's Manual storage
tube
(Figure 7) to vary the
Parking-Brake Lever
The parking-brake lever is located between the seats
(Figure 6 and Figure
engine, engage the parking brake to prevent the
machine from accidentally moving. To engage the
parking brake, pull up the parking-brake lever. To
disengage the parking brake, push the lever down.
Gear-Shift Selector
The gear-shift selector is located between the seats
and below the parking-brake lever. The gear-shift
selector has 3 positions: F
N (Figure
EUTRAL
Note:
The engine starts and runs in any of the 3
positions.
Important:
Always stop the machine before
changing gears.
Horn Button
TC Models Only
g027586
The horn button is located at the lower, left corner of
the dash panel
sound the horn.
1. Horn button (TC Models
only)
2. Hour meter
3. Light switch
4. Battery light
5. Engine oil-pressure light
11
7). Whenever you shut off the
, R
ORWARD EVERSE
6).
(Figure 8). Press the horn button to
Figure 8
6. Engine
coolant-temperature light
7. Glow plug indicator light
8. Key switch
9. Power point
, and
g027587