Toro Workman MDX-D Operator's Manual page 24

Maintenance Service
Interval
Every 100 hours
Every 150 hours
Every 200 hours
Every 300 hours
Every 400 hours
Every 600 hours
Every 800 hours
Every 1,000 hours
Note:
Download a free copy of the electrical schematic by visiting www.Toro.com and searching for your
machine from the Manuals link on the home page.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
WARNING
Failing to properly maintain the machine could result in premature failure of machine systems,
causing possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.
CAUTION
Only qualified and authorized personnel should maintain, repair, adjust, or inspect the machine.
• Avoid fire hazards and have fire-protection equipment present in the work area. Do not use
an open flame to check fluid levels or leakage of fuel, battery electrolyte, or coolant.
• Do not use open pans of fuel or flammable cleaning fluids for cleaning parts.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Shut off the engine and remove the key from the switch before you perform any maintenance.
Maintenance Procedure
• Grease the bearings and bushings.
• Replace the air filter. Replace the air-filter element sooner if it dirty or damaged.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Inspect the steering and suspension for loose or damaged components.
• Check the front wheel camber and toe-in.
• Check the transaxle-fluid level.
• Check the operation of the neutral gear-shift position.
• Clean the engine-cooling areas.
• Inspect the brakes.
• Change the engine oil (twice as often in special operating conditions; refer to .
• Change the engine-oil filter. Change the oil twice as often during special operating
conditions.
• Clean the primary drive clutch (more often in dusty or dirty conditions).
• Adjust the parking brake, if needed.
• Check the condition and tension of the drive belt.
• Inspect the service and parking brakes.
• Grease the front wheel bearings.
• Inspect the fuel lines and connections.
• Visually inspect the brakes for worn brake shoes.
• Adjust the engine-valve clearance.
• Replace the fuel filter.
• Change the transaxle fluid.
• Change the radiator coolant.
• Change the brake fluid.
24