Toro Workman MDX-D Operator's Manual page 37

Replacing the Headlight
1. Disconnect the battery; refer to
the Battery (page
2. Open the hood; refer to
27).
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly (Figure
Figure 39
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4. Remove the speed clips that secure the
headlight to the headlight bracket
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it
forward through the opening in the front bumper
(Figure 39).
6. Install the new headlight through the opening in
the bumper (Figure
Note:
Ensure the adjustment posts are lined up
with the holes in the mounting bracket behind
the bumper.
7. Secure the headlight assembly with the speed
clips that you removed in step 4.
8. Connect the electrical connector for the harness
to the connector of the lamp assembly
39).
9. Adjust the headlights to direct the beams to
the desired position, refer to
Headlights (page
Disconnecting
34).
Raising the Hood (page
39).
4. Headlight
5. Lamp assembly
6. Harness-electrical
connector
(Figure
39).
(Figure
Adjusting the
37).
Adjusting the Headlights
Use the following procedure to adjust the headlight
beam position whenever a headlight assembly is
replaced or removed.
1. Turn the key switch to the O
on the headlights.
2. At the back of the headlight assembly, rotate
adjustment screws
headlight assembly and align the position of the
cast beam.
g036873
39).
37
position, and turn
N
(Figure 39) to pivot the