Toro Workman MDX-D Operator's Manual page 33

1. Engine-oil filter
8. Remove the drain plug
Note:
Allow the oil to completely drain from the
engine.
9. Install the drain plug and seal
torque the plug to 45 to 53 N∙m (33 to 39 ft-lb).
10. Pour oil into the fill opening until the oil level is
up to the Full mark on the dipstick.
11. Add the oil slowly and check the level often
during this process.
Note:
Do not overfill the engine with oil.
12. Install the oil-fill cap and dipstick firmly in place.
13. Connect the battery and lower the cargo bed.
Changing the Engine-Oil Filter
Service Interval: After the first 50 hours
Every 150 hours/Yearly (whichever comes first)
Change the oil twice as often during special
operating conditions.
1. Drain the oil from the engine.
2. Remove the existing oil filter
3. Apply a light coat of clean oil to the new filter
gasket.
4. Thread the new filter onto the filter adapter until
the gasket contacts the mounting plate, then
tighten the filter an additional 1/2 to 3/4 turn
(Figure 34).
Important:
Do not overtighten the oil filter.
5. Fill the crankcase with the specified oil
32).
Figure 34
2. Drain plug
(Figure 34).
(Figure 34) and
(Figure 34).
6. Start and run the engine to check for oil leaks.
7. Shut off the engine and check the engine-oil
level.
Note:
the engine until the oil level is at the Full mark
on the dipstick.
g027838
(Figure
33
If necessary, add the specified oil into