Setting/Programming - Bartec BCS36 8ex Series Supplementary Description

BCS36x8 Series Connection example
ex
Type 17-A1S4-*HP* and B7-A2S4-****
12.1.3

Setting/programming

The programming barcodes have been taken from the original Zebra Product Reference Guide (PRG).
The functions of the BCS3608
DS3678-HP/ER.
The Guide is available to download from Zebra or from BARTEC:
Zebra support download page:
https://www.zebra.com/us/en/support-downloads.html
- Barcode Scanners
- Ultra Rugged Scanners – DS3608-HP/DS3678-HP and DS3608-ER/DS3678-ER
BARTEC download page:
http://automation.bartec.de/indexE
- Data capture
Set factory defaults
Scan the barcode for factory settings to remove all
customized defaults and set the digital scanner to factory
default settings (factory defaults can be found in the Zebra
PRG, Appendix A, Standard Default Parameters).
Default settings
Default settings of the USB interface (virtual COM)
USB functions only as SPP (Serial Port Profile), HID is not supported.
The supply module Ex i is detected by the host PC as a serial connection (virtual COM interface)
Further customized settings can be performed with the help of the Zebra Product Reference
Guide or the Zebra 123Scan utility.
Programming/setting via the Zebra 123 Scan Utility is not supported via the USM.
A programming cable is required.
Subject to technical changes.
05/2020
and BCS3678
ex
Function
are based on the Zebra DS3608-HP/ER and
ex
Barcode
Hand-held scanner is set as HID device.
RS-232 host parameters
Baud rate:
Parity:
Stop bits:
Data bits:
Hardware handshaking: None
Software handshaking:
9600 baud
None
1-bit
8-bit
None
Page 59 of 78