Supply Module Ex I With Bcs3608; Ex Hand-Held Scanner; Connection Rs232 Via Supply Module Ex I - Type: 17-A1Z0-0025 (E.g. On Ex-Hmi); Components Required - Bartec BCS36 8ex Series Supplementary Description

11.

Supply Module Ex i with BCS3608

11.1 Connection RS232 via supply module Ex i – type: 17-A1Z0-0025
(e.g. on Ex-HMI)
11.1.1

Components required

Functional system
BCS3608
ex
ATEX / IECEx Zone 1/21
NEC / CEC Class I, II, III Division 1
1 x Wired BCS3608
Type: 17-A1S4-1HP0
1 x Supply module Ex i for hand-held scanner BCS3608
Only available for ATEX / IECEx Zone 1/21
Type: 17-A1Z0-0025
1 x Connection cable for connection between universal supply module and scanner
Type: 17-A1Z0-0015 or 17-A1Z0-0016 or 17-A1Z0-0017
To be provided by the customer
1 x RS232 connection cable to the host PC.
Maximum cable length supported: 15 m
Number of cores and recommended cable cross section: see BARTEC User Manual
NB:
1 x – The default setting for the hand-held scanner is as an HID device. The serial
– Please use standard, shielded data lines to prevent external disturbances.
1 x Ex-HMI with serial (COM) interface
The Ex relevant data of the power supply module Ex i must match the Ex relevant data of the
Ex-HMI or any other Ex-device.
The Ex-relevant data of the BARTEC systems can be found in the corresponding Ex certificates,
user manuals and data sheets.
Terminal program or software keyboard wedge for testing virtual COM communication and data
1 x
transmission on the host PC.
Page 48 of 78
BCS36x8 Series
ex
Type 17-A1S4-*HP* and B7-A2S4-****
-IS
hand-held scanner
ex
interface still needs to be activated with the help of a programming barcode.
The supply module is then detected by the Ex-HMI as a series connection.
Recommendation: e.g. use CAT5, similar or higher quality cables
Connection example
ex
ex
(www.bartec.com )
hand-held scanner
Subject to technical changes.
05/2020