Installation Of The Weather Station - RADEMACHER ReWiSo Installation And Operating Instructions Manual

i
Installation of the Weather Station and Connection of the Drive
Insert the cables for the power supply and the drive through the rubber seals on the
underside of the weather station and connect the power supply (L1 /N / PE) and the
drive (PE / N / Up / Down) to the corresponding terminals.
Close the housing by pressing the cover onto the lower section. The cover must engage
on the left and right with an audible „click".

Installation of the Weather Station

Check that the cover and lower section are
correctly engaged. The figure shows the
closed weather station from below.
Latch
Push the housing into the installed bracket
from above. The tabs on the bracket must
engage in the rails of the housing.
The weather station can be removed from the
bracket again by pulling up against the
resistance of the latches.
GB
171