Extension Delay; Retraction Delay - RADEMACHER ReWiSo Installation And Operating Instructions Manual

i
B. Extension Delay
After setting the brightness, now enter the delay time for the extension of the sunshade.
This delay ensures that the sunshade does not constantly extend and retract in the
event of rapidly changing light conditions.
The default setting for the extension is 1 minute. The brightness must therefore lie
above the entered set value (point A of the automatic settings) continuously for 1 minute
before the sunshade is extended. The sunshade therefore reacts quickly to sun.
Adjust the value with
setting of the next parameter.
i
C. Retraction Delay
After setting the extension delay, now enter the delay time for the retraction of the
sunshade.
150
(higher) and (lower). Then press SET to proceed to the
The default setting for the retraction is
12 minutes. The brightness must
therefore lie below the entered set
value (point A of the automatic set-
tings) continuously for 12 minutes
before the sunshade is retracted.
Passing clouds are „masked" in this
way.
GB