Neat D-SERVER Technical Handbook page 88

neat
88
D-SERVER Technical Handbook
Next step is to define the Alarm sequence.
Go to >
Routing Alarm sequence definitions
to the nurses, thereafter everything pauses 6 seconds and finally all DECT phones
start ringing.
Picture 127. Create alarm sequence definitions
To enable the sequences Alarm distribution must be configured. Go to
.
Alarm distribution
Picture 128. Define alarm distribution
As mentioned earlier System ID 1 is not recommended. In this scenario we will
change the System ID to 2222.
Go to
System settings
Picture 129. Set the D-SERVER system ID
Don't forget to Reload the configuration once you are finished with the D-SERVER
configuration.
. The definition below sends out an alarm
>
System parameters
to configure System ID.
>
Routing
NE41 09010-02 v3.0